Recording - Sony STR-DA90ESG Operating Instructions Manual

Recording

You can control both playback and recording
components using the receiver's on-screen display. If
necessary, see the instructions of your recording
component.
p Recording to audio tape or MD
1
Click FUNCTION in the main menu.
2
Click the playback component you want (e.g.,
CD).
3
Click SUB.
INPUT SUB
0 ( )
4
Click REC EDIT.
DISC TRACK D. SKIP
1 2 3 4 5
6 7 8 9 10/0
REC EDIT
INPUT SUB
0 ( )
5
Click a recording component (e.g., TAPE).
PLAYER
RECORDER
The control buttons for both components appear.
"PLAYER" for the playback component, and
"RECORDER" for the recording component.
The arrow indicates the operative component.
arrow
FUNCTION SOUND
PLAYER
/
0 ( )
RECORDER
0 9 ( )
A B
REC
USER
p P = +
>10 ENTER
EXIT
USER
p P = +
CD
VIDEO 1
VIDEO 2
DAT/MD
TAPE
EXIT
SETUP
CD
p P
TAPE
p P
EXIT
Playback/Recording
6
Insert a blank tape into the recording component
(tape deck, etc.) and adjust the recording level, if
necessary.
7
Click REC to start recording, then click the play
button (() on the PLAYER control.
Recording starts. Do not click any RECORDER
controls while recording. This will cut off the
source being recorded.
FUNCTION SOUND
PLAYER
/
0 (
RECORDER
0 9 (
A B
REC
To stop recording
Click the recording component's p control.
To control the recorder after recording
Click RECORDER. RECORDER becomes the operative
component and you can use the RECORDER controls to
rewind and playback the recording (etc.).
Click PLAYER to operate the playback component.
To return to the main menu
Click EXIT.
Digital recording
If you connect your CD player and DAT(or MD) deck using
digital connections (see page 12) and specify the OPTICAL
jacks for both components (see page 25), the previous
operations will let you make digital recordings from CD to
DAT (or MD).
Notes
• Signals input to the DIGITAL input jacks cannot be
recorded through analog connections (i.e., to record a CD
onto a cassette tape, the CD player must be connected to
the receiver's analog (L and R) input terminals).
• If you leave the REC EDIT menu by clicking FUNCTION,
SOUND, or EXIT, recording continues, but control returns
to the PLAYER side, even if you previously clicked
RECORDER.
• Some tape decks require that you press the r REC and (
buttons simultaneously to start recording. To perform
one-button recording from the on-screen display, be sure
to record the recording signal as shown in steps 1 to 7 of
"Registering IR codes" (pages 19 to 21).
• When you record on a component connected to the DAT/
MD REC OUT, TAPE REC OUT or VIDEO 1, 2 OUT jacks,
sound adjustments do not affect the recording.
Getting Started
SETUP
CD
) p P
TAPE
) p P
EXIT
(continued)
29