Tuning Radio Stations - Sony STR-DA90ESG Operating Instructions Manual

Front Panel Operations
Selecting a component directly from the
remote control (USA and Canada only)
1
Press one of the SYSTEM CONTROL FUNCTION
buttons to select the component you want to use.
The receiver and the selected component turn on.
The SYSTEM CONTROL FUNCTION buttons on
the remote are factory-set as follows:
To listen to or watch
Records
Radio programs
Compact Discs (CD)
Digital Audio Tapes (DAT)
or MiniDiscs (MD)
Audio tapes
Video tapes
Laser discs/DVD
TV programs
* "NO CONNECTION" is displayed if you select a
function that was set to "NO" in the FUNCTION set
up menu (see page 54).
If the component does not turn on
Press the power switch on the component.
2
Start playing.
Refer to "Remote Descriptions" on page 48 for
details.
To turn off the components
Press SYSTEM OFF. This will also turn off the video and
audio components connected to the SWITCHED AC
OUTLETs on the back of this unit at the same time.
50
(Remote Short-cuts: USA and Canada only)
Tuning and Presetting the
Radio Stations
The receiver lets you tune a station by scanning
stations (Automatic Tuning), and by selecting preset
stations (Preset Tuning).
For the on-screen operations, see pages 27 to 28.
Press*
PHONO
1
TUNER
CD
2
DAT/MD
3
TAPE
VIDEO 1, VIDEO 2
or VIDEO 3
LD/DVD
TV/DBS
Presetting the radio stations
1
2
3
4
5
6
To change a preset station
Preset a new station at the number you want to change.
Turn FUNCTION to light the "TUNER" function
indicator, then press FM/AM to select FM or AM.
Press DISPLAY so that the frequency appears.
Open the control panel and press TUNING + or –.
The frequency indication changes and scanning
stops when the receiver tunes in a station. To
continue scanning, press + or – again. Press + for
a higher station number; press – for a lower one.
Tune in the station you want.
Open the control panel and press MEMORY.
"MEMORY" appears for a few seconds.
Do steps 3 and 4 before "MEMORY" disappears.
If "MEMORY" disappears, press MEMORY again.
Press SHIFT to select a memory page (A, B or C).
Press PRESET TUNING + or – repeatedly to select
the preset you want.
Press MEMORY again to store the station.
Repeat steps 1 to 5 to preset up to 30 stations.