Table of Contents
Advertisement
Power Supply Wiring
A 12 VDC, 1.5 A power supply is provided with the DTP2 211 transmitter. Follow these
instructions to wire the 2-pole captive screw connector to your power supply:
CAUTION: Risk of minor personal injury:
ATTENTION : Risque de blessure mineure :
•
The DC output cables must be kept separate from each other while the power
supply is plugged in. Remove power before wiring.
•
Les câbles de sortie CC doivent être séparés les uns des autres tant que la
source d'alimentation est branchée. Coupez l'alimentation avant d'effectuer les
raccordements.
ATTENTION:
Do not connect any external power supplies until you have read the
•
notifications
•
Veuillez lire les encadrés «
source d'alimentation externe.
NOTES:
One power supply is included with the transmitter and can normally power both
•
units, if they are both from the Extron DTP2 series.
•
If the ground jumper (JMP 2) is Open (Off), (see
because of ground potential differences, one DTP2 211 unit cannot remotely
power the other unit. Each unit requires a local power supply.
See figure 6 to wire the captive screw connector and secure the power cord to the
extended tail of the connector.
SECTION A–A
Figure 6.
1.
Cut the DC output cord to the length needed.
2.
Strip the jacket to expose 3/16 inch (5 mm) of the conductors.
3.
Slide the leads into the supplied 2-pole captive screw plug and secure them, using a
small screwdriver.
4.
To verify the power cord polarity before connecting the plug, connect the power supply
with no load and check the output with a voltmeter.
5.
Use the supplied tie wrap to strap the power cord to the extended tail of the connector.
on the next page.
Attention
A
Smooth
Ridges
3/16"
A
(5 mm) Max.
Power Connector Wiring
» sur la page suivante avant de brancher une
Internal Settings
POWER
12V
--A MAX
DTP2 T/R 211 • Installation and Operation
ATTENTION
on page 32)
12
Advertisement
Table of Contents
