Juniper Archer 3 Owner's Manual page 8

PDF format. A wealth of other user information is also posted
there. Go to:
Apply a Screen Protector (Optional)
The touchscreen is extremely scratch resistant, so a screen
protector is not included with the Archer 3. If you decide to
apply one, refer to the installation instructions included with
your screen protector for specific details.
Install the Battery Pack and SD Card (Optional)
The Archer 3 uses a rechargeable Li-Ion battery pack. Install
and charge the battery pack as follows:
!
CAUTION: Power-off the Archer 3 before removing the
battery. If you remove the battery without powering-off
the handheld, you may damage the handheld and/or lose
data.
1. The battery compartment is accessed from the back of
the handheld. Loosen the four captive screws holding
the battery compartment door in place using a #1
Phillips screwdriver. Remove the door. You do not need
to remove the hand strap.
!
CAUTION: The Archer 3 is not sealed against water and
dust when the battery door is not installed.
2. If you are using a micro SD card for additional memory,
you can install it now before you install the battery pack
or at another time. See more details about installing an
SD card later in this manual.
4
Archer 3 Rugged Handheld Owner's Manual
http://www.junipersys.com.