Juniper Archer 3 Owner's Manual page 20

Suspending and Resuming the Archer 3
We recommend suspending your handheld if you plan to
turn it off for less than two weeks. While it is suspended, you
should attach it to a wall charger when it is not in use.
Suspending the handheld is different from powering it off.
When the device is suspended it goes into a very low power
mode. Some battery power is used during suspend.
1. Press and release the power button
shuts off. It can take several seconds to fully suspend,
especially when the cell modem is on.
2. To resume the device from suspend mode, press and
release the power button again. When it is resumed,
the handheld resumes where it was before it was
suspended.
3. There is also a Suspend option on the Power Button
menu.
Resetting the Archer 3
If the Archer 3 is unresponsive, slow, or programs won't
launch, performing a reset might solve the issue. You
may be asked to perform a reset when an application is
installed.
!
CAUTION: Be aware that during a reset, applications are
closed and unsaved work may be lost.
Follow these steps to reset your Archer 3:
1. Save open files, and close any running programs.
2. Press and hold the power button
Button menu appears.
3. Tap Reset.
You can also reset the handheld by pressing the power
button for 10 seconds or until the screen goes dark. After
a few seconds, the handheld automatically turns on. This
method is useful if your Archer 3 locks up.
Powering Off and On the Archer 3
To preserve battery power, we recommend you power off
the Archer 3 if it will not be used for two weeks or longer.
16
Archer 3 Rugged Handheld Owner's Manual
. The backlight
until the Power