Juniper Archer 3 Owner's Manual page 21

CAUTION: Be aware that when the Archer 3 is powered
!
off, it closes all programs and powers down all system
components except for the real-time clock. Unlike suspend
mode, the device resets when it is powered on again. Any
unsaved data is lost.
1. Save open files, and close any running programs.
2. If you are using external power, unplug it.
3. Press and hold the power button
Button menu appears.
4. Tap Power Off. A warning dialog appears. Tap OK.
To power on your handheld, press the power button.
Restoring the Archer 3 to its Factory State (Clean Boot)
Follow the steps below to restore user storage, settings, and
icons on your Archer 3 to their original factory defaults.
!
CAUTION: Restoring the Archer 3 to its original factory state
permanently erases data saved on the handheld, any
software you installed, and any changes you made to the
handheld, including changes to settings.
1. Back up files and programs you want to keep onto
another computer.
2. Save open files and close running programs on the
handheld. Press and hold the power button
Power Button menu appears. Tap Reset.
3. When the screen turns black, press and hold the
power button
4. Move the top slider on the screen to the right to set or
clear factory defaults. This clean boots the handheld.
5. Tap Exit. The boot process continues.
again. The bios screen is shown.
Chapter 2 Standard Features
until the Power
until the
17