Juniper Archer 3 Owner's Manual page 14

Touchscreen Touch Control Setting
To adjust the Touchscreen Control setting, go to Settings
> Touch Control. Select the profile you want the screen
optimized for: Finger, Stylus, or Wet. As the new profile loads,
a progress bar is shown. You can try different profiles to
see which one works best for the conditions the Archer 3 is
being used in.
Note: When using the Archer 3 in wet conditions, you must
use your finger or the blunt tipped stylus that is included.
A hard-tipped stylus will not work. Other third party styli
might work with the Mesa 2 touch profiles, but we cannot
guarantee it.
Keyboard Features
The Archer 3 has a numeric keypad and function keys. The
keys are sealed and have backlight illumination. Some keys
have dual functions and are programmable. Go to Settings
> Keypad to see what the keys are set to and to make
adjustments
Power Management
The Archer 3 uses a Li-Ion rechargeable battery pack.
!
CAUTION: Only use batteries designed for the Archer 3 from
an approved vendor. Use of non-approved batteries may
void your product warranty.
Charging the Battery Pack
To charge the battery pack, suspend the handheld, then
refer to the instructions in Chapter 1, Getting Started. It
typically takes 4 to 5 hours to fully charge a battery pack.
We recommend that you keep the handheld battery pack
charging when it is not in use for up to two weeks. When you
plug the handheld into the wall charger that comes with it,
the batteries are prevented from being overcharged.
The Li-Ion battery pack is charged most efficiently at room
temperature (68°F or 20°C). The battery pack will not charge
if it is too hot or too cold.
10
Archer 3 Rugged Handheld Owner's Manual