Disassembly; Cleaning - Silvercrest SFE 450 D2 Operating Instructions Manual

__CPE284970_Fruchtentsafter_B4.book Seite 12 Donnerstag, 1. Dezember 2016 8:35 20

8.1 Disassembly

1. Pull the food pusher 2 off upwards from
the food chute 3.
2. For thorough cleaning in the dishwash-
er, and in order to remove the brush-
es 12: rotate the lid of the food
pusher 1, so that one of the arrows
points at the open lock symbol
food pusher 2, and remove the lid.
3. Figure B: release the two safety catch-
es 15 at the lower end, and unhook
them from the lid 18 at the top.
4. Remove the lid 18 upwards.
5. Hold the pulp container 16 by the two
recessed grips and lift it away from the
motor block 7 at a slight angle.
6. Remove the lid 9 from the juice contain-
er 11 upwards.
7. Pull the foam separator 10 upwards out
of the juice container 11.
8. Using both hands, pull out the juice col-
lector pan 5 with the micro-mesh strain-
er 4 upwards.
9. Remove the micro-mesh strainer 4 from
the juice collector pan 5.
10.Disassembly is completed. Begin the
cleaning process.
12 GB

8.2 Cleaning

Outer surfaces
• Clean the motor block 7 and the power
cable 8 with a soft, slightly moistened
cloth.
Cleaning by hand
on the
WARNING!
The micro-mesh strainer 4 must not be
cleaned in a dishwasher.
NOTE:
• The brush 12 included in delivery for
cleaning the micro-mesh strainer 4 is lo-
cated inside the food pusher 2 upon de-
livery. It can be stored there after
thorough cleaning.
• Figure A: rotate the lid of the food
pusher 1, so that one of the arrows
points at the open lock symbol
food pusher 2. From inside the food
pusher 2, remove the brush 12 includ-
ed in delivery.
• The micro-mesh strainer 4 can be
cleaned with the brush 12. Hold the mi-
cro-mesh strainer 4 under flowing water
and clean it from both sides with the
brush 12.
on the