Disassembly; Assembly - Silvercrest SFE 450 D2 Operating Instructions Manual

__CPE284970_Fruchtentsafter_B4.book Seite 8 Donnerstag, 1. Dezember 2016 8:35 20

5.1 Disassembly

The device is delivered completely assem-
bled. For cleaning before the first use, the
device must be disassembled.
1. Pull the food pusher 2 off upwards from
the food chute 3.
2. Figure A: rotate the lid of the food
pusher 1, so that one of the arrows
points at the open lock symbol
food pusher 2. From inside the food
pusher 2, remove the brush 12.
3. Reattach the lid of the food pusher 1 to
the food pusher 2, so that one of the ar-
rows points at the open lock symbol
Turn the arrow to point at the closed
lock symbol .
4. Figure B: release the two safety catch-
es 15 at the lower end, and unhook
them from the lid 18 at the top.
5. Remove the lid 18 upwards.
6. Hold the pulp container 16 by the two
recessed grips and lift it away from the
motor block 7 at a slight angle.
7. Remove the juice container 11 from the
pulp container 16.
8. Remove the lid 9 from the juice contain-
er 11.
9. Pull the foam separator 10 upwards out
of the juice container 11.
10.Using both hands, pull out the juice col-
lector pan 5 with the micro-mesh strain-
er 4 upwards.
11.Remove the micro-mesh strainer 4 from
the juice collector pan 5.
12.Disassembly is completed. Begin the
cleaning process (see "Cleaning and
storing" on page 11).
8
GB

5.2 Assembly

1. Before operation, fully unwind the pow-
er cable 8 from around the cable
spool 20.
2. Place the device on a dry, level, non-slip
and heat-resistant surface.
3. Figure C: place the juice collector
pan 5 on the motor block 7.
4. Figure D: tilt the pulp container 16
on the slightly and push it under the outlet of the
juice collector pan 5. Then slide it towards
the device at the bottom.
5. Figure E: place the micro-mesh strain-
er 4 onto the drive unit 6. Rotate the mi-
. cro-mesh strainer 4 if necessary, until it
fits into the recesses and can be pressed
down completely. It must sit firmly on the
drive unit 6.
6. Figure E: replace the lid 18.
7. Figure F: close the safety catches 15
by placing them on top of the lid 18
and pushing them down until they click
into place.
NOTE:
• The device will only work if it has been
assembled correctly and the safety
catches 15 are firmly closed.
8. Figure G: fit the food pusher 2 into the
food chute 3 on the lid 18 in such a
manner, that the little ridge 19 on the
edge of the food chute 3 fits into the
groove on the food pusher 2.
9. Figure H: slide the foam separator 10
into the holder in the juice container 11
from above. An opening is left at the
bottom.
10.Place the lid 9 onto the juice contain-
er 11.
11.Slide the juice container 11 under the
outflow of the juice collector pan 5.