Interruptions During Juice Extraction - Silvercrest SFE 450 D2 Operating Instructions Manual

__CPE284970_Fruchtentsafter_B4.book Seite 10 Donnerstag, 1. Dezember 2016 8:35 20
5. Remove the food pusher 2 from the
food chute 3, fill the prepared foodstuffs
into the chute 3 and close it as quickly
as possible with the food pusher 2.
6. Press the food pusher 2 down slowly
with only a little pressure. In this way
you achieve the greatest juice extraction
yield.
7. To pause the juice extraction process,
turn the on/off switch 14 to 0. Empty
the pulp container 16 if necessary:
- Open the safety catches 15.
- Remove the lid 18.
- Tilt the pulp container 16 slightly, re-
move it and empty it.
8. Empty the juice from the juice contain-
er 11 at the latest when the maximum
filling level of 1 litre has been reached.
NOTE:
• The foam separator 10 ensures that
most of the foam stays in the juice con-
tainer 11. Pour the juice out slowly.
9. To switch off the device, turn the on/off
switch 14 to 0. Unplug the mains
plug 8 and wait until the micro-mesh
strainer 4 has come to a standstill be-
fore you take off the lid 18. Clean the
device as soon as possible after use.
10 GB
7.2 Interruptions during juice
extraction
Operating period
If the device has been in operation for 30
minutes without interruption, switch it off un-
til the motor block 7 has cooled down com-
pletely.
Emptying the micro-mesh
strainer / removing blockages
• The micro-mesh strainer 4 must be emp-
tied when...
... the juice coming out becomes thicker,
... if juice is coming out between the
lid 18 and the juice collector pan 5
or
... when the motor becomes audibly
slower.
• Blockage: if a piece of fruit or vegeta-
ble is blocking the micro-mesh strain-
er 4, it must be removed immediately.
You can recognise a blockage...
... if no more juice is produced,
... if the fruit can no longer be pressed
down in the food chute,
... if there are unusual sounds, or
... when the motor becomes audibly
slower.
• Proceed as follows:
- Turn the on/off switch 14 to 0.
- Pull out the mains plug 8.
- Wait until the micro-mesh strainer 4
has come to a standstill.
- Open the safety catches 15.
- Remove the lid 18.
- Lift off the juice collector pan 5 with
the micro-mesh strainer 4 upwards.
- Remove the micro-mesh strainer 4
and empty it.
- Reassemble the parts and proceed
with juice extraction.