Replacement - Henny Penny 600 Service Manual

Remove entire gas burner assembly, by lifting and pulling toward front of fryer.
9 9 ) )
• Replace the thermocouple (3) as required, per
Assembly , page
• Repair or replace or replace gas control valve (1) as required, see
Gas Burner Assembly , page
• Replace orifices (8) as required, see
28.
NOTICE:
Make other repairs or replacements as required.
1 1 0 0 ) )
Install entire gas burner assembly.
1 1 1 1 ) )
Install u-bolt (3) to rinse hose bracket and gas line.
1 1 2 2 ) )
Turn the filter valve handle (4) to the CLOSED position.
1 1 3 3 ) )
Loosen the two screws (13) which are holding the heat shield deflector (9) in the
1 1 4 4 ) )
high position, and lower it to the normal operating position, see
Shield Deflector Assembly , page
Tighten the two screws (13) on the heat shield, see
1 1 5 5 ) )
Deflector Assembly , page
Connect gas supply line (1) to the gas control valve connector (2), see
1 1 6 6 ) )
8 Gas Supply Connection , page
Install the wires onto gas control valve.
1 1 7 7 ) )
Remove control panel and install it in the slot above door.
1 1 8 8 ) )
Connect the gas control valve wires to the thermostat and high temperature limit
1 1 9 9 ) )
control as labeled.
Install control panel per
2 2 0 0 ) )
Uncap and reconnect the main gas supply line to the fryer. turn on the main gas
2 2 1 1 ) )
supply.
D D A A N N G G E E R R ! !
Connect the service cord to the wall receptacle, or close circuit breakers.
2 2 2 2 ) )
Relight the gas pilot per the instructions in Chapter 2-10 Gas Pilot & Burner
2 2 3 3 ) )
Lighting and Shutdown Procedure of the Operator's Manual.
2 2 . . 1 1 3 3 T T h h e e r r m m o o c c o o u u p p l l e e
2 2 . . 1 1 3 3 . . 1 1 D D e e s s c c r r i i p p t t i i o o n n
The thermocouple controls the gas control valve. it generates voltage in the multivolt.
this voltage signals the gas control valve to remain open to the pilot and burner. When
28.
28.
Figure 2-7 Gas Burner Assembly , page
There are 23 brass orifices and 1 stainless steel orifice.
The stainless steel orifice is to be mounted adjacent to
the pilot light.
30.
30.
30.
2.4.1 Raise the Control , page
L L e e a a k k i i n n g g g g a a s s m m a a y y c c a a u u s s e e a a n n e e x x p p l l o o s s i i o o n n . . C C h h e e c c k k f f o o r r
l l e e a a k k s s p p e e r r O O p p e e r r a a t t o o r r ' ' s s M M a a n n u u a a l l . .
Figure 2-7 Gas Burner
Figure 2-7
Figure 2-9 Heat
Figure 2-9 Heat Shield
Figure 2-
14.
31