Siemens CP 1243-1 Operating Instructions Manual page 137

Note the conditions for the safe deployment of the CP according to the section Link:
(https://support.industry.siemens.com/cs/ww/en/ps/15922/cert).
You should also note the information in the document "Use of subassemblies/modules in a
Zone 2 Hazardous Area" that you will find on the Internet at the following address:
Link: (https://support.industry.siemens.com/cs/ww/en/view/78381013)
c(UL)us
Applied standards:
● Underwriters Laboratories, Inc.: UL 61010-1 (Safety Requirements for Electrical
Equipment for Measurement, Control, and Laboratory Use - Part 1: General
Requirements)
● IEC/UL 61010-2-201 (Safety requirements for electrical equipment for measurement,
control and laboratory use. Particular requirements for control equipment)
● Canadian Standards Association: CSA C22.2 No. 142 (Process Control Equipment)
File Number: E223122
cULus Hazardous (Classified) Locations
Underwriters Laboratories, Inc.: cULus IND. CONT. EQ. FOR HAZ. LOC.
Applied standards:
● ANSI ISA 12.12.01
● CSA C22.2 No. 213-M1987
APPROVED for Use in:
● Cl. 1, Div. 2, GP. A, B, C, D T4A; Ta = -20 °C...60 °C
● Cl. 1, Zone 2, GP. IIC T4; Ta = -20 °C...60 °C
Report / UL file: E223122 (NRAG.E223122)
Note the conditions for the safe deployment of the CP according to the section Notices
regarding use in hazardous areas according to UL HazLoc (Page 33).
FM
Factory Mutual Approval Standard Class Number 3600, 3611, 3810, ANSI/ISA-61010-1
Equipment rating:
Class I, Division 2, Group A, B, C, D, Temperature Class T4A, Ta = 60 °C
Class I, Zone 2, Group IIC, Temperature Class T4, Ta = 60 °C
Report Number: 3049779, 3049925
Note the conditions for the safe deployment of the CP according to the section Notices on
use in hazardous areas according to FM (Page 33).
CP 1243-1
Operating Instructions, 04/2017, C79000-G8976-C365-03
Approvals
137