Sony JumboTron Operating Instructions Manual page 28

Adjusting the Luminance Manually
28
5
Press the ENTER button to finish the setting.
The display returns to the MANUAL ADJUST menu.
6
Press the ENTER button again to confirm the mode.
The whole unit blinks.
M A N U A L A D J U S T
L o a d : F a c t o r y D a t a
L u m i n a n c e : 0 7 F
B r i g h t n e s s : 0 7
H : 0 1
U N I T T Y P E : L D U - 3 0
7
Press the HOLD button.
The unit stops blinking and "HOLD!" appears in the display window.
M A N U A L A D J U S T
L o a d : F a c t o r y D a t a
L u m i n a n c e : 0 7 F
B r i g h t n e s s : 0 7
H = 0 1
U N I T T Y P E : L D U - 3 0
8
When you select "Load: Factory Data" or "Load: User Data" in
step 2
Press the ENTER button.
The display unit reads the respective data to display.
After about 15 seconds the display returns to that in step 2.
When you select "Save" in step 2
Press the WRITE button.
The displayed data are saved and the selected test signal with the SPG
button appears.
After about 15 seconds the display returns to that in step 2.
Pressing the ENTER button cancels saving and the display returns to
that in step 2.
To save the factory preset data
Perform steps 2 to 8 to display the factory preset data, select "Save" in step
2 again, then save the data through steps 6 to 8.
The factory preset data will not be saved by selecting "Load: Factory
Data" and displaying the data.
( W h i t e )
V : 0 1
( W h i t e )
V = 0 1
H O L D ! HOLD!