Sony JumboTron Operating Instructions Manual page 15

2 Specifying the luminance, brightness, scroll speed and color bar width of the
selected test signal
Specify after displaying the test signal on the JumboTron display unit by
steps 1 to 5 above.
6
Press the SETUP button.
The items to be specified and their current data (in hexadecimal)
appear in the display window.
S P G S e t U p
S P G : C O L O R B A R - V
Cursor
L U M : 0 7 F
B R T : 0 7
S P D : 0 3
W I D : 0 1
B L U E
R E D
G R E E N : 0 7 F
C L K : N T S C
L I N E : 0 6 4
U N I T T Y P E : J T U - 3 5
When you select RASTER in step 4, the following display appears.
S P G : R A S T E R
L U M : # # #
B R T : 0 7
S P D : - -
W I D : - -
B L U E
R E D
G R E E N : 0 2 A
C L K : N T S C
L I N E : 0 6 4
U N I T T Y P E : J T U - 3 5
7
Select the item to be specified with the ◊ or √ button.
8
Change the data by pressing the ∫ or ı button or the numeric buttons.
• Each time you press the ∫ button, the level increases by 1, and
pressing the ı button decreases the level.
• You can also change the level by pressing the numeric buttons that
correspond to its level (for example, press 0, 7 and F to set the level to
7F).
Example: Setting LUM (luminance) to 7F.
S P G S e t U p
S P G : C O L O R B A R - V
L U M : 0 7 F
B R T : O A
S P D : 0 3
W I D : 0 1
B L U E
R E D
Note
There are some items that cannot be specified according to the test signals.
The cursors of these items are shown as " ", and the levels of the data are
shown as "– –" or "###".
S P G S e t U p
S P G : R A S T E R
L U M : # # #
B R T : 0 7
S P D : - -
W I D : - -
B L U E
R E D
G R E E N : 0 2 A
Items to be specified
Luminance
Brightness
Scroll speed
Color bar width
: 0 7 F
Items to be specified in
: 0 7 F
RASTER display mode
Clock of the output signal
Number of display lines
S P G S e t U p
: 0 7 F
: 0 5 2
: 0 7 F
: 0 7 F
: 0 7 F
: 0 5 2
Items to be specified
Brightness
Luminance of blue
Luminance of red
Luminance of green
(Continued)
15