Table of Contents
Advertisement
Adjusting the Luminance Manually
22
7
To change the target of adjustment, select "Target" with the ◊ or √
button, then press the ∫ or ı button to change.
The display changes in the order of UNIT, CELL and PIXEL each
time you press the ∫ button. (It changes in the reverse order each time
you press the ı button.)
When you select G1-VOLTAGE or REF-VOLTAGE in the procedure
1 , PIXEL does not appear.
Example: Selecting the cell for the target of adjustment
A D J U S T S e t U p
A D J : P W M - W H I T E
T a r g e t : C E L L
L u m i n a n c e : 0 7 F
B r i g h t n e s s : 0 7
U N I T T Y P E : J T U - 3 5
8
To change the luminance or brightness of the whole unit, select
"Luminance" or "Brightness" with the ◊ or √ button, then change the
data with the ∫ or ı button, or the numeric buttons.
The adjustable range is 256 levels from 000 to 0FF for luminance, and
16 levels from 00 to 0F for brightness.
The level increases by 1 when you press the ∫ button and decreases by
1 when you press the ı button. You can also select the level by
pressing the numeric buttons that correspond to its level (for example,
to set it to 07F, press 0, 7 then F).
Example: Setting the brightness to 0A
A D J U S T S e t U p
A D J : P W M - W H I T E
T a r g e t : C E L L
L u m i n a n c e : 0 7 F
B r i g h t n e s s : O A
U N I T T Y P E : J T U - 3 5
9
Press the ENTER button to finish the setting.
The selected target of adjustment, luminance and brightness data are
stored in the memory. The stored data are retained, even after the unit
alignment sensor is turned off, until adjustment is made.
The display returns to the MANUAL ADJUST menu.
To cancel the setting before storing
Press the SETUP button before pressing the ENTER button in step 9. The
data are not stored and the display returns to the menu in step 4.
Advertisement
Table of Contents
