80
Position of the pedal
The pedal (2) is assembled to the cross strut of the stand. You can
adjust the position of the pedal as needed by moving the cross
strut.
To set the position of the pedal:
1.
Loosen the screw with wing nut (3) on both sides of the stand.
2.
Slide the cross strut that holds the pedal (2) forward or
backward.
3.
Tighten the screw with a wing nut (3) on both sides of the stand.
7.11 Electrical connection
DANGER
Risk of death from live components!
Unprotected contact with electricity can result in
serious injuries or death.
Only qualified specialists may perform work on
electrical equipment.
Important
The voltage on the type plate of the sewing motor must correspond
to the mains voltage.
To establish the electrical connection:
1.
Connect the machine as specified in the wiring diagram;
see Appendix ( p. 99).
Operating Instructions 195 - 01.0 - 11/2017
Setup