Table of Contents
Advertisement
68
To complete the upper side of the tabletop:
1.
Press the lower hinge parts (1) into the rear slots in the tabletop
cutout.
2.
Press the rubber corners (3) into the front slots in the tabletop
cutout.
Fig. 42: Completing the tabletop (2)
⑦
(7) - Tilt sensor
3.
Tighten the permanent magnets of the tilt sensor (7) in the
tabletop cutout using 2 screws.
Information
The permanent magnet is included in the accessory pack.
The tilt sensor has been pre-assembled on the machine head at
the factory. As long as the tilt sensor is assembled without the
permanent magnet (7), the machine remains locked and cannot
be used for sewing.
4.
Knock the tilt protection device (8) into the tabletop (2) using
a hammer.
You can now assemble the following parts:
• Main switch
• Pedal and setpoint device ( p. 72)
• If applicable, the sewing lamp transformer
• If applicable, the knee button ( p. 74)
• Control ( p. 69)
• Reel stand ( p. 70)
Use each of the center marks on the underside of the tabletop (2)
for orientation.
⑧
(8) - Tilt protection device
Operating Instructions 195 - 01.0 - 11/2017
Setup
Advertisement
Table of Contents
