Table of Contents
Advertisement
30
Fig. 16: Setting the needle thread quantity (2)
②
③
④
(2) - Screws
(3) - Needle thread regulator
To set the needle thread quantity:
1.
Turn the handwheel until the thread lever (1) reaches its lower
end position.
2.
Loosen the screws (2) of the needle thread regulator (3).
3.
Move the needle thread regulator (3) to the correct position.
• For tight and normal seams (detail image (a)):
Feed the needle thread over the right bar of the needle
thread regulator (3), through the hole of the thread
lever (4), and then straight down.
• For elastic seams (detail image (b)):
Feed the needle thread over the right bar of the needle
thread regulator (3), through the hold of the thread
lever (4), over the left bar of the needle thread
regulator (3), and then down.
4.
Tighten the screws (2) for the needle thread regulator (3).
(a)
(4) - Hole of the thread lever
Operating Instructions 195 - 01.0 - 11/2017
Operation
(b)
②
③
④
Advertisement
Table of Contents
