Changing The Paper Width - Epson TM-L90-i Technical Reference Manual

Changing the Paper Width

This printer is shipped from the factory with the roll paper width set to 80mm. To use roll paper
with a width of 38mm to 70mm, install a roll paper spacer using the following procedure.
 Since it is possible for some areas of the printer head and the auto cutter blades to
 To change the paper width, use the memory switch to change the paper width settings.
1
To use roll paper with a width of 61mm to 70mm, fold the tabs in two
locations on the roll paper spacer.
Even if the tabs are folded, you can still use roll paper with a width of 38mm to 60mm.
2
Open the roll paper cover.
3
Insert the roll paper spacers through the grooves on the inside edges of
the printer, and downward.
Edge
become worn through direct contact with the platen, it is not possible to change from a
narrow width to a wider width once operation has started.
Chapter 2 Setup
Groove
57
2