Connecting To External Devices - Epson TM-L90-i Technical Reference Manual

Connecting to External Devices

Follow the steps below to connect external devices to the interface section.
 When connecting external devices to the USB (including Micro-USB) connectors,
CAUTION
 When using the printer, make sure the protective cover fits firmly into place.
 When LAN cables are installed outdoors, make sure devices without proper surge
 Connecting the optional Wireless LAN Cable Set (OT-WL01) to the USB connector
 For the Micro-USB connector, use the Micro USB (A-Micro B type) cable.
1
Connect each cables to the connectors at the back of the printer.
Drawer kick-out
connector
USB connectors
(for optional products)
2
Connect other ends of the cables to external devices.
follow the precautions below.
 Confirm the rated current of the external devices by checking the descriptions
on the devices or manuals. Do not use a device whose rated current is unclear.
 Use the UL-approved external devices (only for North American users).
 Connect the external devices only when those total rated current is less than
2.0A.
protection are cushioned by being connected through devices that do have surge
protection. Otherwise, the devices can be damaged by lightning.
enables the wireless LAN connection. (See
page 69.)While connecting via wireless LAN, keep the Ethernet cable unconnected to
the printer.
*1: Analog RGB connector (not available currently)
*2: Micro SD card slot (available when using the PHP function .)
"Connecting the wireless LAN cable set" on
*2
*1
Micro-USB (Type AB) connector
(for setting only)
Chapter 4 Handling
Protective cover
UBS connector
(for optional product)
137
4