Erasing Start Ids - Sony PCM-M1 Operating Instructions Manual

Note
Start IDs which were
written during recording
or written after the
selected point cannot be
moved.
To move the Start IDs,
rewrite it after erasing.
Note
If a Start ID is erased, the
program number which is
written on the same point
will be erased also.
34 EN
Recording
3
Press the START ID • ENTER button during
Rehearsal function.
"WRITE" will appear for a moment. "
will flash and the Start ID will be written. During
this step the sound will be muted.
To adjust the selected point
Each time you press the = 0 or ) + button,
the selected point shifts backwards or forwards in 0.3-
second steps, up to a maximum extent of about 10
seconds in either direction.
Selected point
Tape
0.3
Each time you
press the
= 0 button.

Erasing Start IDs

You can erase the Start IDs without erasing the
contents of the existing recording.
Erasing the Start ID is possible only when the recorder
is in the stop or playback mode.
1
Press ) + or = 0 so that you are in the
track after the Start ID you want to erase.
2
Press the START ID • MODE button repeatedly
until "ERASE" appears in the display of the main
unit.
3
Press the START ID • ENTER button.
The tape will automatically
rewind to find the Start ID of
that program (track) and then
" " will flash in the
display and start to erase the
Start ID. During this step the
sound will be muted. Playback
will start when this mode is
done.
0.3
Each time you press
the ) + button.
"