Preventative Maintenance - Jackson 10 Series Installation, Operation And Service Manual

MAINTENANCE
PREVENTATIVE
MAINTENANCE
15

PREVENTATIVE MAINTENANCE

Proper maintenance of your Jackson dishmachine will ensure optimum service with
a minimum of down time.
1. To delime the booster tank.
a. Remove the support pipe nut and lift the whole hood assembly away from the
unit.
b. Loosen the fi tting going into bottom side of booster tank.
c. Drain approximately 2 to 3 cups out of the tank.
d. Pour 1 to 2 cups of delimer into the hood support block opening, after
tightening the booster tank union.
e. Replace the hood assembly.
f. Turn on the heater switch for 30 minutes.
g. Fill the machine with water.
h. Turn on manual wash switch and allow the unit to run for about 20 minutes.
i. Empty the machine and refi ll at least twice.
2. To remove all lime and corrosion deposits.
a. Fill the machine with wash water as would ordinarily be done for washing.
b. Open the door and place one cup or less of deliming compound into the
water. (Be sure to follow their directions if they
vary from these being given) which is available from your detergent supplier.
Read and follow the label instructions.
c. Turn on the manual wash switch and allow to wash for fi ve minutes.
d. Open the door and examine the interior. All lime should be removed and parts
should be shiny. If not, allow to wash for a longer period.
e. After the interior is clean, empty the wash water be removing overfl ow
strainer.
f. Replace the overfl ow strainer. Refi ll machine and allow to run for two minutes,
then again drain the wash reservoir.
g. Refi ll as it is ready for regular operation.
3. Clean strainers.
a. Clean around overfl ow and pump intake strainer holes.
b. Clean around pump intake (a toothbrush makes a good cleaning tool).
4. Clean Y-strainer on the incoming water line. (Water to the machine must be
turned off for this operation.)
a. Remove the plug and clean the strainer.
5. Clean rinse tubes.
a. Remove the end plugs on the lower and upper rinse arms.
b. Clean all rinse tubes with the special brush provided.
c. If spray holes in the rinse tubes are clogged, they may be cleaned with a
pointed tool.
6. Clean the wash head assembly.
a. If the spray jets are plugged, use a pointed tool to dislodge and fl ush with
water.
b. If lodged items still remain in the wash tubes, remove the wash assembly by
fi rst removing the rinse assembly.
c. Clean the assembly at the sink by fl ushing water through the spray jets.
d. Reinstall the wash and rinse assemblies.
7. Clean any deposits which may have built up on exterior moving parts.
07610-002-41-09-F