Sony ZS-M30 Operating Instructions Manual page 32

Labelling recordings (Name
Function) (continued)
Labelling after recording
To label an MD or a track, operate as
follows. You can input up to 100 characters
for each label.
1
When you label an MD, insert the MD
you want to label and stop operation.
When you label a track, play the track
you want to label.
2
Press EDIT repeatedly until "Disc
Name" or "Track Name" appears in the
display, and press YES•ENTER.
When you label an MD, select "Disc
Name".
When you label a track, select "Track
Name".
3
Label the MD or the track according to
steps 3 and 4 on page 31.
4
Press YES•ENTER.
The name is labelled on the MD or the
track.
To change the name
According to steps 1 and 2 on this page,
make the disc name or the track name you
want to change appear in the display.
Replace the old name with a new one, and
press YES•ENTER.
Tip
When using an MD that has been already labelled,
a disc name or a track name appears in the display
at the time of labelling. Change the name
according to steps 3 and 4 on page 31, if
necessary, then press YES•ENTER to confirm the
new name.
GB
32