Coolant Reservoir - Grizzly G0667X Owner's Manual

Power Feed Gearing
Lubricant Frequency
Multi-purpose Every 3
gear grease Months
remove the longitudinal ball handle, then remove
the slotted flat washers from the leadscrew. slide
the graduated dial assembly to the end of the
leadscrew, taking care not to misplace the keys
shown in Figure 56. Apply a thin coat of general
purpose light grease to the drive gear and brass
gear, then reinstall the parts in reverse order.
Keys
drive gear
Brass gear
Figure 56. power feed gearing.
g0667X high precision Vs Vertical Mill
Qty
thin Coat

Coolant Reservoir

Coolant is a potent and
extremely
solution to humans and
animals. use personal
protective
when handling coolant
to prevent infections or
poisoning.
A small amount of coolant is lost during normal
operation. Check the coolant reservoir regularly
and fill it if necessary.
the Model g0667X coolant reservoir holds
approximately 7 gallons (26 liters) of fluid. We rec-
ommend changing this fluid every three months or
sooner if it develops an unpleasant odor.
Checking Coolant Level
Tools Needed
hex Wrench 3mm .............................................. 1
To check the coolant level:
1. disConnECt thE Mill FroM poWEr!
2. Clean away debris and grime from the res-
ervoir screen on the base of the mill, then
remove it to inspect the level of coolant (see
Figure 57).
reservoir screen
Figure 57. reservoir screen on the base.
poisonous
equipment
Qty
-39-