Lubrication - Grizzly G0667X Owner's Manual

Lubrication

your mill has numerous moving metal-to-metal
contacts that require proper lubrication to help
ensure efficient and long-lasting mill operation.
other than lubrication points covered in this sec-
tion, all other bearings are internally lubricated
and sealed at the factory. simply leave them
alone unless they need to be replaced.
NOTICE
Follow reasonable lubrication practices as
outlined in the manual for your mill. Failure
to do so could lead to premature failure of
your mill and will void the warranty.
One-Shot Oiler
Lubricant
primrose Armor plate
Moly-d, or iso 68 sAE
20W equivalent
the oil lines running from the one-shot oiler feed
lubrication to the ways of the column (knee), sad-
dle, and table, as well the longitudinal and cross
feed leadscrews.
pull the handle (see Figure 50) and release it to
send the lubricant through the lines.
Fill Cap
Figure 50. one-shot oiler (on left side of knee).
g0667X high precision Vs Vertical Mill
Frequency Qty
Every 1
8 hours pump
of operation
handle
Quill
Lubricant
iso 68 sAE 20W
r&o gear & Bearing
lubricant
Clean debris and grime from the quill oil cup (see
Figure 51), then lift the cap and add the correct
amount of lubricant to the cup.
oil Cup
Figure 51. Quill oil cup (on left side of the head).
Speed Range Gearing
Lubricant
iso 68 sAE 20W
r&o gear & Bearing
lubricant
Clean debris and grime from the speed range
gearing oil cup (see Figure ), then lift the cap and
add the correct amount of lubricant to the cup.
oil Cup
Figure 52. speed range gearing oil cup.
Frequency Qty
Every 10
24 hours drops
of operation
Frequency Qty
Every 5
40 hours drops
of operation
-37-