Table of Contents
Advertisement
Additional Safety Instructions For Mills
1. uNDERSTANDING CONTROLS. Make
sure you understand the use and operation
of all controls.
2.
SAFETy ACCESSORIES. Always use a
chip guard in addition to your safety glasses
or use a face shield when milling to reduce
the risk of injury from flying chips.
3.
WORK HOLDING. Before starting the
machine, be certain the workpiece has been
properly clamped to the table. nEVEr hold
the workpiece by hand during operation.
4.
CHuCK KEy SAFETy. Always remove
chuck key, drawbar wrench, and any service
tools immediately after use.
5.
SPINDLE SPEEDS. select the spindle
speed that is appropriate for the type of
work and material. Allow the mill to gain full
speed before beginning a cut.
6.
POWER DISRuPTION. in the event of a
local power outage during operation, turn
OFF all switches to avoid possible sudden
start up once power is restored.
7.
STOPPING SPINDLE. do not stop the
spindle using your hand. Allow the spindle
to stop on its own, or, in the case of an
emergency, use the spindle brake.
8.
CLEAN-uP. do not clear chips by hand
or compressed air. use a brush or vacuum,
and never clear chips while the spindle is
turning.
9.
BE ATTENTIVE. do not leave mill run-
ning unattended for any reason.
Like all machinery there is potential danger when operating this mill. Accidents are frequently
caused by lack of familiarity or failure to pay attention. use this mill with respect and caution to
decrease the risk of operator injury. If normal safety precautions are overlooked or ignored, seri-
ous personal injury may occur.
g0667X high precision Vs Vertical Mill
10. MACHINE CARE AND MAINTENANCE.
never operate the mill with damaged or
worn parts. Maintain your mill in proper
working condition. perform routine inspec-
tions and maintenance promptly. put away
adjustment tools after use.
11. DISCONNECT POWER. Make sure the mill
is turned OFF, disconnected from its power
source and all moving parts have come to a
complete stop before changing cutting tools,
starting any inspection, adjustment, or main-
tenance procedure.
12. AVOIDING ENTANGLEMENT. do not
wear loose clothing, gloves, or jewelry when
operating mill. tie back long hair and roll up
sleeves.
13. TOOLING. Always use the proper tooling
for your operation. Make sure tooling is held
firmly in place.
14. CuTTING TOOL INSPECTION. inspect
drills and end mills for sharpness, chips,
or cracks before each use. replace dull,
chipped, or cracked cutting tools immedi-
ately. handle new cutting tools with care.
leading edges are very sharp and can
cause lacerations.
15. SPINDLE DIRECTION CHANGES. to avoid
damage to the gears, never reverse spindle
direction while the spindle is in motion.
16. EXPERIENCING DIFFICuLTIES. if at any
time you are experiencing difficulties per-
forming the intended operation, stop using
the machine! Contact our technical support
at (570) 546-9663.
-11-
Advertisement
Table of Contents
