Headstock Reservoir - Grizzly G0755 Owner's Manual

Headstock Reservoir

oil type ......Model t23962 or iso 68 equivalent
oil Amount ................................................ 3
Check/Add Frequency ...........8 hrs. of operation
Change Frequency ................................ Annually
the headstock has the proper amount of oil when
the sight glass is halfway full (see Figure 42).
Figure 42. headstock sight glass.
Tool Needed
hex Wrench 8mm .............................................. 1
To change the headstock oil:
1.
run the spindle at 670 rpM for approximate-
ly 10 minutes to warm the oil.
2.
disConneCt MAChine FroM poWer!
3. remove the fill plug (see Figure 43).
Fill
plug
Figure 43. headstock oil fill plug.
Model G0755 (Mfg. Since 1/13)
4.
⁄ Qt.
1
4
5.
sight
glass
Qty
6.
7.
8.
place a 1-gallon or larger drain pan on the
table under the headstock.
remove the drain plug (see Figure 44) from
underneath the headstock. Allow the oil to
completely drain into the pan.
drain
plug
Figure 44. headstock drain plug
(headstock tilted 90° for clarity).
Follow federal, state, and local require-
ments for proper disposal of used oil.
replace the drain plug.
Add oil until the sight glass is halfway full,
then replace the fill plug.
Clean up any spilled oil to prevent slipping
hazards.
-31-