Sony DAV-IS10 Operating Instructions Manual page 16

3
Connect the cords to the AM antenna (aerial) terminals.
The cords can be connected to either terminal.
Insert the cords pushing down the terminal clamp.
Note
• Do not place the AM loop antenna (aerial) near the system or other AV equipment, as noise may result.
Tip
• Adjust the direction of the AM loop antenna (aerial) for best AM broadcast sound.
4
Make sure the AM loop antenna (aerial) is connected firmly by pulling softly.
To connect the FM wire antenna (aerial)
Connect the FM wire antenna (aerial) to the FM 75 Ω COAXIAL jack.
Note
• Be sure to fully extend the FM wire antenna (aerial).
• After connecting the FM wire antenna (aerial), keep it as horizontal as possible.
Tip
• If you have poor FM reception, use a 75-ohm coaxial cable (not supplied) to connect the control unit to an outdoor
FM antenna (aerial) as shown below.
16
US
Insert until this
part.
FM wire antenna (aerial)
(supplied)
FM 75 Ω COAXIAL jack
Rear of the control unit
DMPORT
DMPORT
Outdoor FM antenna (aerial)