Integrated Switch Network Manager (Isnm) - IBM Power Systems 775 Manual

3.1.6 Integrated Switch Network Manager
In this section, a new set of commands specific for the IBM Power Systems 775 cluster are
described. The Integrated Switch Network Manager (ISNM) integrates the Cluster Network
Manager (CNM), and the hardware server daemons. For more information, see Table 3-1 on
page 158.
The following commands are described in this section:
lsnwcomponents
lsnwdownhw
lsnwexpnbrs
lsnwgc
lsnwlinkinfo
lsnwloc
lsnwmiswire
lsnwtopo
lsnwcomponents
For this command, we list the help description that is shown in Figure 3-14. A typical output is
shown in Example 3-40 on page 200.
# lsnwcomponents -h
Usage: lsnwcomponents [ -B | --BPA | -F | --FSP ] [ -p | --page ] [ -h |
--help ]
The options can be given either with '-' or '--'.
Figure 3-14 lsnwcomponents command flag description
The lsnwcomponents command lists integrated switch network components. The following
input and output values are used:
Command: lsnwcomponents
Flags:
– -B: Filters BPA output only
– -F: Filters FSP output only
Outputs:
[no-flags]
[BPA | FSP] [Primary | Backup] ip=<ip_active> MTMS= <model>-<type>*<serial_number>
Designations:
– ip: Hardware component IP
– MTMS: Hardware part, Model, Type and Serial Number
Attributes:
– <ip_active>: X.X.X.X (IP)
– <model>: Model number
– <type>: Type 3 hexadecimal code
– <serial_number>: Seven hexadecimal code
<active_service_processor>
Chapter 3. Monitoring assets
199