Isolated Rs485 Interface Pcb; Cables And Wiring - Honeywell Notifier ID3000 Series Installation & Commissioning Manual

Make sure you have
a PC back-up of the
current
configuration data
WARNING -
Disconnect ALL power
from the ID3000 Series
panel
Upper Edge
Socket SK2 or SK3 on Base PCB
RS485 PCB - Part Number 124-247
997-274-000-6, Issue 6
September 2009
ID3000 Series Installation & Commissioning Manual

5.12 Isolated RS485 Interface PCB

The ID3000 Series Isolated RS485 Interface PCB
(PN: 124-247) enables the ID3000 Series Fire Control Panel
to be networked to other ID3000 Series control panels (via
Master/Slave network) or the connection of ID3000 Series
repeater panels. The Isolated RS485 Interface PCB is located
adjacent to and at the left-hand side of the Base PCB. The
PCB is secured in position using one metal spacer and SEM
screw and three nylon snap-top spacers, all provided with
the Isolated RS485 Interface PCB Kit (PN: 020-479).
To fit the Isolated RS485 Interface PCB follow the
instructions below. Only one Isolated RS485 Interface
PCB is supported.
Before starting, make sure you have a PC back-up of
the panel's current configuration data.
Ensure you take appropriate anti-static precautions
before undertaking this procedure.
With the front cover moulding(s) removed (see Section 2.7)
and ALL power disconnected, proceed as follows:
1 Using a suitable-sized coin, release the two quarter-turn
2 Fit the metal spacer (E) through the Base PCB to the
3 Fit the three supplied nylon snap-top spacers (G)
4 Observing anti-static precautions, remove the RS485
5 Use the M3 x 8mm SEM screw (I) to secure the Isolated
6 Make all necessary wiring connections to the Isolated
7 If no other PCBs require fitting, close and secure the
8 To replace the Isolated RS485 Interface PCB, first reverse
Note: Refer to Section 6, Repeaters and Networking,

5.12.1 Cables and Wiring

9 Make the following wiring connections to the Isolated
Lower Edge
i
ii Cable at socket SK1 from the next station on the
40
fasteners (A) located at the left-hand side of the main chassis
front door (B). Open the door to gain access to the main
chassis' PCB enclosure (C) containing the Base PCB (D).
top left fixing position of either PCB mounting location
(F). Tighten down fully using a 5.5mm Hex socket tool.
through the Base PCB by pushing them firmly into
place until they snap into position.
Interface PCB from its packaging. If, after inspection,
no damage has occurred in transit and with it correctly
orientated, carefully offer the PCB to the three snap-
top spacers described in step 3. Working in a clockwise
direction, carefully push the PCB onto the snap-top
spacers (positions H) until the PCB is secure.
RS485 PCB to the metal spacer (position J).
RS485 Interface PCB - see details below.
main chassis front door, re-connect mains power and
the batteries and replace the front cover moulding.
the above procedure, steps 4 to 7, and then fit the
replacement RS485 Interface PCB using steps 4 to 7.
for details of the jumpers (K).
RS485 Interface PCB:
Ribbon cable at socket SK2 from the Base PCB socket
SK2 or SK3.
network (as applicable).