Options Available On The Valve; Chlorine Generator (Check Salt Light) - Pentair AUTOTROL Performa 263 Installer Manual

3.4.

Options available on the valve

3.4.1. Chlorine generator (check salt light)

The Logix 740 and 760 controllers have the capability to produce a low level of chlorine to chlorinate
the resin bed during regeneration. A check salt light will indicate when the user needs to add salt to
the brine tank. Potassium chloride or sodium chloride may be used.
No.
A Unplug the wall-mounted transformer.
B Shut off water supply or put bypass valve(s) into bypass position.
C Relieve system pressure before performing any operations.
D Unlock the cover (2) from the slide clips (1) (one on each side of the valve).
E Remove the controller (3) by pressing on (4).
F Connect the small chlorine generator connector to the back of the controller (5).
Remove the existing refill controller (6) with the ball (7) from the valve and replace it with
G
the one provided in the kit.
Connect the other end of the cable to the refill controller previously installed.
H
Connect firmly to ensure a good contact.
I Reverse above procedure steps to rebuild.
Note
No programming is necessary for the chlorine generator to work properly on the controller.
A
The system will be automatically functional after the chlorine generation senses brine for
the first time. There is a check salt light on the front of the controller that will illuminate
when there is no brine present during the brine draw.
Ref. MKT-IM-011 / A - 15.06.2017
Installer Manual Performa 263-268 / LOGIX 740-760 - Description
Operation
Chlorine generator
(check salt light)
13 / 64