Troubleshooting; Logix Controller - Pentair AUTOTROL Performa 263 Installer Manual

Installer Manual Performa 263-268 / LOGIX 740-760 - Troubleshooting
10.

Troubleshooting

10.1. Logix controller

Err. code
Controller power has been connected
ERR 1 and the controller is not sure of the
operating status.
Controller power does not match 50 or
ERR 2
60 Hz.
Controller lost the position of
camshaft. Camshaft should be rotating
to find Home position.
Camshaft does not rotate.
ERR3
Camshaft rotates for more than 5
minutes to find Home position.
52 / 64
Cause Reset and recovery
Reset controller.
See 6.4.3. Resetting the controller,
page 37.
Disconnect and reconnect the power.
If problem is not solved, obtain an
appropriate controller or AC
transformer.
Wait for 2 minutes: the controller
returns to Home position.
An hourglass icon flashes to indicate
that the motor is running.
Check:
• Motor connections.
• If motor wire harness is connected
to the motor.
• If motor wire harness is connected
to the controller.
• Optical sensor connection and
position.
• If motor and camshaft gears are
engaged.
If everything is connected, try
replacing in this order:
• Wire harness.
• Motor.
• Optical sensor.
• Controller.
See 9.2. Cleaning and maintenance,
page 44.
Check:
• Optical sensor connection and
position.
• Camshaft connection.
• Camshaft slots cleanness.
Ref. MKT-IM-011 / A - 15.06.2017