Programming The Remote - Sony Bravia KLV-V26A10 Operating Instructions Manual

To connect Do this
Digital satellite Connect only to the HDMI IN
receiver or digital jack. The digital video and audio
terrestrial receiver signals are input from the digital
E
satellite receiver.
Tip
If the digital satellite receiver has an
HDMI jack, connecting via an HDMI
cable will provide the best results.
Note
When using an HDMI-to-DVI cable
or an adapter, be sure to connect the
DVI output connector first; then
connect to the HDMI jack on the TV.
DVD recorder or Connect to the video output jacks
VCR F
to record the image from the
TV. Connect to the audio output
jacks
the TV on the DVD recorder or
VCR. To turn off the sound of the
TV speakers, set "Speaker" to
"Off" (page 37).
DVD player with Connect to the component jack
component output 1, 2 and the audio jacks
G
1, 2. For better picture quality,
component connection is
recommended if your DVD player
has a component output.
Video game Connect to the S video jack
equipment, DVD or the video jack
player without the audio jacks
component video avoid picture noise, do not connect
output, or VCR the camcorder to the video jack
HI
1 and the S video jack
at the same time. If you connect
mono equipment, connect to the L
(MONO) jack
Hi-Fi audio Connect to the audio output jacks
equipment J
to listen to the sound from the
TV on the Hi-Fi audio equipment.
To turn off the sound of the TV
speakers, set "Speaker" to "Off"
(page 37).
to record the sound from
1
1, 2 or 3, and
1, 2 or 3. To
1
1, 2 or 3.
Programming the
remote
If you have Sony VCRs/DVDs and Sony DVD Home
Theater Systems/Amplifiers, do the following
procedure to program the remote so that you can
operate them using this remote.
Note
Before you start, look up the three-digit code for your
equipment on the right. For equipment that has more than
one code, try with the first code number.
1
Press and hold the DVD, VCR, or AMP
function button you want to program on the
remote and press the
simultaneously.
The selected function button (DVD, VCR, or
AMP) will flash.
2
Enter the three-digit code using the number
buttons while the function button is lit (for
approximately 10 seconds).
3
Press /-/-- or
programming.
When the programming is done successfully, the
selected function button will flash twice slowly, and
if not, will flash five times quickly.
1
2
3
1
/ button
to complete the
49
GB