Programming The Remote Control (For Rm-Yd057 And Rm-Yd067 Remote Control Users) - Sony KDL-46HX820 Service Training Manual

Programming the Remote Control
(For RM-YD057 and RM-YD067 remote control users)
Your remote control can be programmed to use other equipment and is pre-programmed to
operate the following Sony equipment.
Function Button Sony Equipment Code Number
DVD DVD Player
AMP Receiver
STB Digital Satellite
Programming Other Equipment
2
2
4
3
Confirm the Programming
If you can turn your equipment on and off using the green POWER button, the
programming is complete. If not, try the next code listed.
~
• In some cases, you may not be able to program your remote control. If this is the case, use your
equipment's own remote control.
• Any of the function buttons (DVD, AMP, STB) can be programmed to operate other equipment
regardless of the labeling. For example, if programmed with the correct code, a Blu-ray Disc player
can be operated with the DVD button. This is useful if your equipment does not match any of the
labeled buttons.
To reset the remote control to the factory default:
Press SCENE, TV "/1 (TV POWER), and
(DVD, AMP, STB, and TV) blink when successfully reset.
26
31033
52172
01639
Follow the steps below to program your TV remote control.
1 Look for the code in the Manufacturer's Code List (refer to
i-Manual) that corresponds to the equipment you would like to
operate with the Sony remote control. If more than one code is
provided, try programming the first code listed. If your
equipment's code is not listed, visit
http://esupport.sony.com/remotecodes for a more comprehensive
list.
2 Press and hold DVD, AMP or STB function button
simultaneously with t button and release.
When in the programming mode, the function button (DVD,
AMP, STB) blinks for approximately 30 seconds until a code is
entered.
3 Enter the five digit code using
buttons (DVD, AMP, STB) are lit. If the code is not entered
within 30 seconds, you must repeat step 2.
4 Press to confirm the code. If successfully programmed, the
function button (DVD, AMP, STB) will blink twice, if not, it
blinks five times.
-
simultaneously. The four function buttons
while the function