Adjusting The Viewing Angle Of The Tv - Sony Bravia KLV-V26A10 Operating Instructions Manual

1
Connect your antenna with the antenna
cable (supplied).
If connecting to an antenna only (A)
Connect the male plug to the
(antenna) jack on the rear of the TV, then go to
step 3.
Notes
• Note that one end of the cable has a male plug fitted
while the other end is fitted with a female jack.
• Do not connect the AC power cord until all other
connections are complete; otherwise, a minimal
current leakage through the antenna and/or other
terminals to the ground could occur.
If connecting to a VCR with an antenna (B)
Connect your antenna to the input jack on your
VCR.
Notes
• If you connect a monaural VCR, connect the yellow
t
plug to VIDEO (the yellow jack) and the black
plug to AUDIO-L (MONO) (the white jack).
• If you connect a VCR to the 8 VHF/UHF (antenna)
jack, preset the signal output from the VCR to the
program number 0 on the TV.
• If the S video cable is connected to this TV and the
VCR, the S video signal is automatically selected.
2
Connect your VCR.
Connect the output jack on your VCR to the input
jack on the rear of the TV.
3
Connect the AC power cord (supplied) to
the AC IN jack on the rear of the TV.

Adjusting the viewing angle of the TV

This TV can be adjusted within the angles shown
below.
Adjust the angle back and forth (tilt)
(KLV-V26A10/KLV-V32A10 only)
3° 8°
Right view
Front
Adjust the angle left and right (swivel)
Top view
15°
15°
Front
VHF/UHF
8
15°
15°
Note
Do not connect the AC power cord to the AC power jack
until all connections are complete.
4
Bundle the cable.
1
B
A
2
3
1 Attach the cable holder (supplied) to the rear
of the TV ( A ), then turn the cable holder a
quarter turn to the left ( B ).
2 Push the clasp lever in to release the lock and
open the cover, and then insert the cables.
3 Close the cover, then pull the clasp lever up to
lock the cover.
Note
When adjusting the angle, hold the stand with one hand to
avoid slipping or tipping the stand.
15
GB