Programming The Remote - Sony Bravia KDL-52X2000 Operating Instructions Manual

Programming the
remote
If you have Sony VCRs/DVDs and Sony DVD Home
Theater Systems/Amplifiers, do the following
procedure to program the remote so that you can
operate them using this remote.
Note
Before you start, look up the three-digit code for your
equipment from the "Equipment's codes" on page 40.
1
Press and hold the DVD, VCR or AMP
function button you want to program on the
remote, then press
function button pressed down.
The selected function button (DVD, VCR or
AMP) will flash.
2
Press the number buttons to enter the
three-digit code while the button is lit. If
code is not entered within 10 seconds, you
must perform the step 1 again.
3
Press .
When the programming is correct, the selected
function button will flash twice, and when not, it
will flash five times.
40
GB
1
2
1
3
, keeping the
4
Switch on your equipment and check that
the following main functions work.
H (playback), x (stop), m (rewind), M (fast
forward), channel selection for both VCR and
DVDs, TOP MENU/MENU and
for DVDs.
If your equipment is not working, or some of the
functions do not work
Enter the correct code or try the next code listed.
To return to normal TV operation
Press the TV function button.
Equipment's codes
Equipment Code
VCR 001*, 002, 003, 004
DVD 101*, 151, 201, 202, 203
Amplifier 301, 302, 303, 304, 401*, 402, 403, 451
* Factory setting
F f G g
/ / / only