Refrigerator
6.4 Installing the drain water hose
FIRE HAZARD. Do not allow the drain tube to contact the burner assembly or boiler casing.
Failure to obey this warning could cause a fire resulting in death or serious injury.
I
Read before proceeding:
• The perforated plug must be present at the end of the drain water hose.
• The drain water hose must not be kinked or routed uphill.
52
Hose
Option 1 - through the floor
➤ Drill a hole through the flooring.
➤ Place sealant around the hole.
➤ Confirm that the supplied hose is long enough.
➤ Supply an extra length of hose, if needed.
Option 2 - through vent frame (plastic vents only)
➤ Pull the end of the hose through the louvers in the vent door.
➤ Cut the hose to length.
➤ Reinstall the perforated plug.
Option 3 - hanging clip (plastic vents only)
➤ Install the clip (not provided, part number 3106559.xxx) during vent installation.
➤ Insert the hose into the "j" portion of clip.
➤ Cut the hose to length.
➤ Reinstall the perforated plug.
➤ Ensure that the hose is positioned to drain into the uppermost row of louvers in the vent door.
Option 4 - through vent door (side-by side plastic vent only)
➤ Drill a 5/8" hole in the vent frame directly above the floor line.
➤ Route the drain hose through the hole and cut it to length.
➤ Reinstall the perforated plug on the outside of the vent frame.
➤ Apply sealant around the plug to ensure water does not seep into the enclosure.
Option 5 – attached to vent frame (3316941.xxx, 3317027.xxx, and 3317024.xxx only)
➤ Remove the perforated plug.
➤ Cut the hose to length.
➤ Push the end of the hose through the attachment feature located on the vent frame.
EN
30