Section 3: Safety - Taylor 336 Original Operating Instructions

Section 3
We at the Taylor Company are concerned about the
safety of the operator when he or she comes into contact
with the freezer and its parts. Taylor has gone to extreme
efforts to design and manufacture built-in safety features
to protect both you and the service technician. As an
example, warning labels have been attached to the
freezer to further point out safety precautions to the
operator.
IMPORTANT - Failure to adhere to the
following safety precautions may result in severe
personal injury. Failure to comply with these warnings
may damage the machine and its components.
Component damage will result in part replacement
expense and service repair expense test.
DO NOT operate the freezer without reading
the Operator Manual. Failure to follow this instruction
may result in equipment damage, poor freezer
performance, health hazards, or personal injury.
This appliance is to be used only by trained
personnel. It is not intended for use by children or people
with reduced physical, sensory, or mental capabilities, or
lack of experience and knowledge, unless given
supervision or instruction concerning the use of the
appliance by a person responsible for their safety.
Children should be supervised to ensure that they do not
play with the appliance.
This equipment is provided with an
equipotential grounding lug that is to be properly
attached to the rear of the frame by the authorized
installer. The installation location is marked by the
equipotential bonding symbol (5021 of IEC 60417- 1) on
the removable panel and the frame.
Safety
DO NOT use a water jet to clean or rinse the
freezer. Failure to follow these instructions may result in
serious electrical shock.
• DO NOT allow untrained personnel to operate
this machine.
• DO NOT operate the freezer unless all service
panels and access doors are restrained with
screws.
• DO NOT remove any internal operating parts
(examples: freezer door, beater, scraper blades,
etc.) unless all control switches are in the OFF
position.
Failure to follow these instructions may result in severe
personal injury to fingers or hands from hazardous
moving parts.
This unit has many sharp edges that can
cause severe injuries.
• DO NOT put objects or fingers in the door spout. This
may contaminate the product and cause severe
personal injury from blade contact.
• USE EXTREME CAUTION when removing the
beater assembly. The scraper blades are very sharp.
• DO NOT operate the freezer unless it is properly
grounded.
• DO NOT operate freezer with larger fuses than
specified on the data label.
• All repairs must be performed by an authorized
Taylor service technician.
• The main power supplies to machine must be
disconnected prior to performing repairs.
Model 336, 338, 339
Safety
3
3-1