Section 2: To The Operator - Taylor 336 Original Operating Instructions

Section 2
The freezer you have purchased has been carefully
engineered and manufactured to give you dependable
operation. The Taylor softserve models covered in this
manual consist of the following: 336, 338, and 339.
These units, when properly operated and cared for, will
produce a consistent quality product. Like all mechanical
products, they will require cleaning and maintenance. A
minimum amount of care and attention is necessary if the
operating procedures outlined in this manual are followed
closely.
This Operator's Manual should be read before operating
or performing any maintenance on your equipment.
Your Taylor freezer will not eventually compensate for
and correct any errors during the setup or filling
operations. Thus, the initial assembly and priming
procedures are of extreme importance. It is strongly
recommended that personnel responsible for the
equipment's operation, both assembly and disassembly,
go through these procedures together in order to be
properly trained and to prevent misunderstandings.
When requiring technical assistance, please contact your
local authorized Taylor distributor.
Note: Your Taylor warranty is valid only if the parts are
authorized Taylor parts purchased from the local
authorized Taylor distributor and if all required service
work is provided by a Taylor service technician. Taylor
reserves the right to deny warranty claims on units or
parts if unapproved parts or incorrect refrigerant were
installed in the unit, system modifications were performed
beyond factory recommendations, or it is determined that
the failure was caused by abuse, misuse, neglect, or
failure to follow all operating instructions. For full details
of your Taylor warranty, please see "Section 10: Limited
Warranty on Equipment" and "Section 11: Limited
Warranty on Parts".
To the Operator
Note: Constant research results in steady
improvements; therefore, information in this manual is
subject to change without notice.
If the crossed-out waste container symbol is
affixed to this product, it signifies that this product is
compliant with the EU Directive as well as other similar
legislation in effect after August 13, 2005. Therefore, it
must be collected separately after its use is completed,
and cannot be disposed as unsorted municipal waste.
The user is responsible for returning the product to the
appropriate collection facility, as specified by your local
code.
For additional information regarding applicable local
laws, please contact the municipal facility and/or local
distributor.
Model 336, 338, 339
To the Operator
2
2-1