Repositioning The Cooker Following Connection; Fit The Handles; Fitting The Splash Back (Optional) - Rangemaster Classic Deluxe 110 Dual Fuel with FSD User Manual

Fig.7-10
Stability bracket
3 mm min
ArtNo.070-0014 - Stability bracket - Wall fitting
Fig.7-11
Outer stability
bracket
3 mm min
Wall
ArtNo.070-0015 - Stability bracket - Wall fitting
Fig.7-12
ArtNo.215-0026 - Handle gaskets fixed
Fig.7-13
ArtNo.210-0006 - Classic fitting the handles 2
Fig.7-14
Art No 215-0028 - Handrail fascia fixings
Check the appliance is electrically safe when you have finished.
Cooker
Floor
Cooker
Floor
INSTALLATION
Adjust and lock the inner stability bracket to give a 3 mm
clearance above the engagement edge in the back of the
cooker (Fig.7-10).
Wall Fixing
Where floor fixing is impractical and provided that the outer
stability bracket can be attached to a solid wall, the stability
bracket may be attached to a wall (Fig.7-11). Make sure to
use suitable screws and fixings.
Repositioning the Cooker following
Connection
If you need to move the cooker once it has been connected,
make sure it is switched off at the supply switch before
gripping under the fascia panel and lifting the front of
the cooker slightly (Fig.7-8). Check behind the cooker to
ensure that the electricity cable
As you progress, always ensure that the cable
sufficient slack to allow the cooker to move.
If a stability chain is fitted, release it as you ease the cooker out.
Do not forget to refit it when you replace the cooker.
When you replace the cooker, check behind it again once
more to ensure that the electricity cable
caught or trapped.

Fit the Handles

Remove the 4mm Allen screws (Fig.7-12) from the doors with
the hexagon (Allen) key tool. Use the screws to fit the door
handles (Fig.7-13).
The handles should be above the fixings.
Remove the 4mm Allen screws (Fig.7-14) from the top
corners of the fascia and fix the front handrail in position.

Fitting the splash back (optional)

Remove the two fixing screws (3mm hexagonal socket head)
and nuts that pass through the top of the rear flue grille. Hold
the splash back in position. From the rear refit the two fixing
screws and nuts.
28
or gas hose is not caught.
and hose have
or gas hose is not