Completing The Move; Conversion To Another Gas; Fitting A Stability Bracket - Rangemaster Classic Deluxe 110 Dual Fuel with FSD User Manual

Removing the Storage Drawer
Pull the drawer out to its furthest point (Fig.7-5).
Push the ends of the plastic clips - down on the left-hand
side, and up on the right-hand side - to release the catches
holding the drawer to the side runners. At the same time pull
the drawer forward and away from the side runners
For safety's sake push the drawer runners back out of the way
and put the drawer somewhere safe until the installation is
complete.
Lowering the rear rollers
There are two adjusting nuts, one for each roller, at both the
front bottom corners of the cooker.
To adjust the height of the rear of the cooker, first fit a 13 mm
spanner or socket wrench on to the hexagonal adjusting nut
(Fig.7-7).
Make sure you lower BOTH REAR ROLLERS.
Rotate the nut - clockwise to raise the cooker - anti-clockwise
to lower the cooker.

Completing the Move

Unfold the rear edge of the
Open the grill door and right-hand oven door so that you
can get a good grip on the bottom of the fascia panel as you
move the cooker.
Grip under the fascia panel and lift the front of the cooker
slightly (Fig.7-8).
Carefully push the cooker backwards off the base tray.
Remove the base tray. Position the cooker close to its final
position, leaving just enough space to get behind it.
DO NOT use the door handles or control knobs to
nn
manoeuvre the cooker.
To adjust the height of the front of the cooker, turn the screw-
down feet - clockwise to raise - anti-clockwise to

Conversion to Another Gas

If the appliance is to be converted to another gas do the
conversion at this stage of
See the conversion section of these instructions and see the
instructions in the conversion kit.

Fitting a Stability Bracket

When fitting a stability bracket please refer to the instructions
supplied with the bracket for further details on fitting.
Floor Fixing
Assemble the parts (Fig.7-9).
Using suitable screws and fixings, attach the assembled
bracket to the floor to give a minimum engagement of
65 mm into the back of the cooker.
Check the appliance is electrically safe when you have finished.
cardboard base tray.
lower.
installation.
INSTALLATION
(Fig.7-6).
A
27
B
A
Fig.7-6
Fig.7-7
Fig.7-8
Fig.7-9
B