Bandinfo Number Configuration; Work Frequency - Huawei EG860 Series User Manual

EG860
User Guide
Step 3 Set WAN Antenna. Set Antenna status based on the actual product.
The EM350-D61 data card supports only Outer Antenna. The EM350-C71 data card supports
Outer Antenna, Inner Antenna, and Outer Antenna Prefer.
Step 4 Set WIFI antenna.
antenna.
Step 5 Optional: Set Wan auto reset.
This parameter is valid only if General Settings > Internet Settings > Connection mode is set
to auto.
Step 6 Click Submit.
----End

7.7.12 Bandinfo Number Configuration

This section describes how to check Localbandinfo and check and configure Airbandinfo on the
Bandinfo Number Configuration page.
Procedure
Step 1 Choose System > BandInfo. The Bandinfo Number Configuration page is displayed.
Step 2 Configure AirBandInfo.
A minimum of one record and a maximum of eight records can be configured for AirBandInfo
based on the following requirements:
1.
2.
3.
4.
----End

7.7.13 Work Frequency

This section describes how to set the working frequency of a modem on the Work
Frequency interface.
Context
After the working frequency is changed, the modem is restarted.
Procedure
Step 1 Choose System > Work Frequency. The Frequency Settings interface is displayed.
Step 2 Set BandID. The value range is 0-63. 0 indicates that the frequency is not locked.
Step 3 Set Frequency. The value range is 0-65535. 0 indicates that the frequency is not locked.
Issue 02 (2015-04-10)
MIMO
Set each parameter to a value within the corresponding range.
Uniquely set AirBand ID. The ranges from Earfcn_Low to Earfcn_High of different cells
cannot overlap.
The range from Freq_Low to Freq_High of AirBand must be a subset of that of Localband.
one AirBand corresponds to one LocalBand or multiple AirBands correspond to one
LocalBand.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
is used in 802.11n mode, so set Antenna status to Double WIFI
7 Reference
104