Step 5: Preparing The Remote; Controlling Tvs With The Remote - Sony RDR-GX220 Operating Instructions Manual

Step 5: Preparing the
Remote
You can control the recorder using the
supplied remote. Insert two R6 (size AA)
batteries by matching the 3 and # ends on
the batteries to the markings inside the
battery compartment. When using the
remote, point it at the remote sensor
recorder.
b
Notes
• If the supplied remote interferes your other Sony
DVD recorder or player, change the command
mode number for this recorder (page 17).
• Use the batteries correctly to avoid possible
leakage and corrosion. Should leakage occur, do
not touch the liquid with bare hands. Observe the
following:
– Do not use a new battery with an old battery, or
batteries of different manufacturers.
– Do not attempt to recharge the batteries.
– If you do not intend to use the remote for an
extended period of time, remove the batteries.
– If battery leakage occurs, wipe out any liquid
inside the battery compartment, and insert new
batteries.
• Do not expose the remote sensor (marked
the front panel) to strong light, such as direct
sunlight or a lighting apparatus. The recorder may
not respond to the remote.
16
Controlling TVs with the
remote
You can adjust the remote's signal to control
your TV.
b
Notes
• Depending on the connected unit, you may not be
able to control your TV with some or all of the
buttons below.
on the
• If you enter a new code number, the code number
previously entered will be erased.
• When you replace the batteries of the remote, the
code number may be reset to the default setting.
Set the appropriate code number again.
Number
buttons
TV 2 +/–
TV PROG
+/–
1
on
Hold down the TV [/1 button located
at the bottom of the remote.
Do not press the [/1 button at the top of
the remote.
2
With the TV [/1 button pressed down,
enter the TV's manufacturer code
using the number buttons.
For instance, to enter "09," press "0" then
"9." After you enter the last number,
release the TV [/1 button.
TV [/1
TV t