Setting the thread cutter
Fig. 59: Setting the initial position of the thread cutter and the position of the thread-pulling
knife (1)
(1) - Assembly opening
(2) - Lever
To set the initial position of the thread cutter and the position of the thread-
pulling knife:
1. Move the handwheel into the 80° position.
2. Loosen the screw on the lever (2) through the assembly opening (1).
3. Loosen the screw (3) on the lever (4).
Service Instructions 969 - 06.0 - 03/2019
①
(3) - Screw
(4) - Lever
②
③
④
77