Fig. 55: Setting the winder (3)
①
②
③
④
(1) - Winder lever
(2) - Screw
(3) - Counternut
(4) - Bobbin
1. Turn the winder lever to position 0.
The winder is switched off.
2. Loosen the screw (6).
3. Turn the eccentric (5) so that there is a gap of 0.5 mm between
4. Tighten the screw (6).
Fig. 56: Setting the winder (4)
(9) - Blocking lever
(10) - Blocking cam
5. Loosen the screws (12).
6. Set the position of the microswitch (11).
7. Tighten the screws (12).
72
the friction disk (8) and the rubber pulley (9).
⑨
⑩
⑪
⑫
Setting the thread system
0.5 mm
(5) - Eccentric
(6) - Screw
(7) - Rubber pulley
(8) - Friction disk
(11) - Microswitch
(12) - Screws
Service Instructions 969 - 06.0 - 03/2019
⑧
⑦
⑥
⑤