Mercedes-Benz Sprinter 907 2018 Operating Instructions Manual page 290

288
Breakdown assistance
When the starting assistance/charging process is
complete:
First, remove the jump leads/charging cables
#
from the earth point and negative terminal of
the other vehicle's battery, then from the pos‐
itive terminal of jump-starting connection
point 1 and the positive terminal of the
other vehicle's battery. Each time, begin at
the contacts on your own vehicle.
The red protective cap springs back to its ini‐
tial position when positive terminal clamp
is disconnected from jump-starting connec‐
tion point 1.
Further information can be obtained at a qualified
specialist workshop.
Fitting and removing the floor covering (vehi‐
cles with rear-wheel drive)
& WARNING Risk of accident due to
objects in the driver's footwell
Objects in the driver's footwell may impede
pedal travel or block a depressed pedal.
This jeopardises the operating and road
safety of the vehicle.
Stow all objects in the vehicle securely
#
so that they cannot get into the driver's
footwell.
Ensure floor mats and carpets cannot
#
slip and provide sufficient room for the
pedals.
Do not lay multiple floor mats or carpets
#
on top of one another.
Switch off all electrical consumers.
#
To remove: remove screws
#
trim 2.
Remove floor covering 1.
#
To fit: insert floor covering
#
the base of the driver's seat and at the door
sill.
Put trim 2
#
back in.
2
Disconnecting the starter battery
* NOTE Damage to the electrical assembly
If you disconnect the starter battery before
you have switched off the engine and
removed the key from the ignition lock, elec‐
trical assemblies could be damaged.
Switch off the engine and remove the
#
key from the ignition lock. Then remove
the battery terminals from the starter
battery. Make sure you always discon‐
nect the starter battery in the battery
case in the left-hand footwell first. Oth‐
erwise, electrical assemblies, e.g. the
alternator, could be damaged.
* NOTE Damage to the vehicle's electron‐
ics
If you do not disconnect the battery as descri‐
bed here, the vehicle's electronics could be
damaged.
Always disconnect the starter battery in
#
following the sequence, and do not
reverse the battery terminals under any
circumstances. Otherwise, the vehicle's
electronics could be damaged.
3 and take off
1 and align it at
in place and screw screws 3