Table of Contents
Advertisement
2. Important Notes
In addition to the items listed under "Using the unit safely" on p. 4, please read and observe the following:
Power Supply
• Do not connect this unit to same electrical outlet
that is being used by an electrical appliance that
is controlled by an inverter or a motor (such as a
refrigerator, washing machine, microwave oven, or
air conditioner). Depending on the way in which
the electrical appliance is used, power supply noise
may cause this unit to malfunction or may produce
audible noise. If it is not practical to use a separate
electrical outlet, connect a power supply noise filter
between this unit and the electrical outlet.
• The AC adaptor will begin to generate heat after
long hours of consecutive use. This is normal, and is
not a cause for concern.
• To prevent malfunction and equipment failure,
always make sure to turn off the power on all your
equipment before you make any connections.
• With the factory settings, the BK-9 will
automatically be switched off 30 minutes after you
stop playing or operating the unit. If you don't want
the unit to turn off automatically, change the "AUTO
OFF" setting to "OFF" as described on p. 143.
NOTE
The settings you were editing will be lost when the
unit is turned off. If you want to keep your settings,
you must save your settings before turning the
unit off.
Placement
• Using the unit near power amplifiers (or other
equipment containing large power transformers)
may induce hum. To alleviate the problem, change
the orientation of this unit; or move it farther away
from the source of interference.
• This device may interfere with radio and television
reception. Do not use this device in the vicinity of
such receivers.
• Noise may be produced if wireless communications
devices, such as cell phones, are operated in the
vicinity of this unit. Such noise could occur when
receiving or initiating a call, or while conversing.
Should you experience such problems, you should
relocate such wireless devices so they are at a
greater distance from this unit, or switch them off.
• Do not expose the unit to direct sunlight, place
it near devices that radiate heat, leave it inside
an enclosed vehicle, or otherwise subject it to
temperature extremes. Excessive heat can deform
or discolor the unit.
• When moved from one location to another where
the temperature and/or humidity is very different,
water droplets (condensation) may form inside
the unit. Damage or malfunction may result if you
attempt to use the unit in this condition. Therefore,
before using the unit, you must allow it to stand
for several hours, until the condensation has
completely evaporated.
• Do not allow objects to remain on top of the
keyboard. This can be the cause of malfunction,
such as keys ceasing to produce sound.
• Depending on the material and temperature of the
surface on which you place the unit, its rubber feet
may discolor or mar the surface.
You can place a piece of felt or cloth under the
rubber feet to prevent this from happening. If you
do so, please make sure that the unit will not slip or
move accidentally.
• Do not put anything that contains water on this
unit. Also, avoid the use of insecticides, perfumes,
alcohol, nail polish, spray cans, etc., near the unit.
Swiftly wipe away any liquid that spills on the unit
using a dry, soft cloth.
6
Maintenance
• For everyday cleaning wipe the unit with a soft,
dry cloth or one that has been slightly dampened
with water. To remove stubborn dirt, use a cloth
impregnated with a mild, non-abrasive detergent.
Afterwards, be sure to wipe the unit thoroughly
with a soft, dry cloth.
• Never use benzine, thinners, alcohol or solvents of
any kind, to avoid the possibility of discoloration
and/or deformation.
Additional Precautions
• Unfortunately, it may be impossible to restore the
contents of data that was stored on a USB memory
once it has been lost. Roland Europe assumes no
liability concerning such loss of data.
• Use a reasonable amount of care when using the
unit's buttons, sliders, or other controls; and when
using its jacks and connectors. Rough handling can
lead to malfunctions.
• Never strike or apply strong pressure to the display.
• When disconnecting all cables, grasp the connector
itself—never pull on the cable. This way you will
avoid causing shorts, or damage to the cable's
internal elements.
• To avoid disturbing others nearby, try to keep the
unit's volume at reasonable levels. You may prefer
to use headphones, so you do not need to be
concerned about those around you.
• When you need to transport the unit, package it
in the box (including padding) that it came in, if
possible. Otherwise, you will need to use equivalent
packaging materials.
• Do not apply undue force to the music stand while
it is in use.
• Use only the specified expression pedal (EV-
series; sold separately). By connecting any other
expression pedals, you risk causing malfunction
and/or damage to the unit.
• Some connection cables contain resistors. Do not
use cables that incorporate resistors for connecting
to this unit. The use of such cables can cause the
sound level to be extremely low, or impossible
to hear. For information on cable specifications,
contact the manufacturer of the cable.
• The sensitivity of the D Beam controller will change
depending on the amount of light in the vicinity of
the unit. If it does not function as you expect, adjust
the sensitivity as appropriate for the brightness of
your location.
• When opening/closing the USB memory cover,
please be careful not to get your fingers pinched
between the movable part and the panel. In places
where small children are present, make sure that an
adult provides supervision and guidance.
Storage devices that can be connected
to the BK-9's USB MEMORY port
• The BK-9 allows you to connect commercially
available USB Flash memory. You can purchase
such devices at a computer store, a digital camera
dealer, etc.
• Though external hard disks with a capacity in
excess of 2TB can be used, please bear in mind that
the BK-9 can manage a maximum of 2TB. (FAT-32
formatted storage devices can be used right away.)
• Use USB memory sold by Roland (M-UF-series).
We cannot guarantee operation if any other USB
memory is used.
Before using external USB storage
devices
• Carefully insert the USB memory all the way in—
until it is firmly in place.
• USB memories are constructed using precision
components; handle the storage devices carefully,
paying particular note to the following.
• To prevent damage to the USB memory from
static electricity, be sure to discharge any static
electricity from your own body before handling
the cards.
• Do not touch or allow metal to come into
contact with the contact portion of the USB
memory.
• Do not bend, drop, or subject cards to strong
shock or vibration.
• Do not keep cards in direct sunlight, in closed
vehicles, or other such locations.
• Do not allow USB memories to become wet.
• Do not disassemble or modify the USB memory.
• Never touch the terminals of the USB memory. Also,
avoid getting the terminals dirty.
• When connecting a USB memory, position it
horizontally with the BK-9's USB MEMORY port
and insert it without using excessive force. The
USB MEMORY port may be damaged if you use
excessive force when inserting a USB memory.
• Do not connect or disconnect a USB drive while it
is being rear from, or written to (i.e., while the USB
flash access indicator blinks).
• Do not insert anything other than a USB memory
(e.g., wire, coins, other types of device) into the USB
MEMORY port. Doing so will damage the BK-9's USB
MEMORY port.
• Never connect your USB memory to the BK-9 via a
USB hub.
• Do not connect or disconnect a USB drive while it
is being rear from, or written to (i.e., while the USB
flash access indicator blinks).
Liability and copyright
• Recording, duplication, distribution, sale, lease,
performance, or broadcast of copyrighted material
(musical works, visual works, broadcasts, live
performances, etc.) belonging to a third party in
part or in whole without the permission of the
copyright owner is forbidden by law.
• Do not use this unit for purposes that could
infringe on a copyright held by a third party. Roland
assumes no responsibility whatsoever with regard
to any infringements of third-party copyrights
arising through your use of this unit.
• Roland, SuperNATURAL are either registered
trademarks or trademarks of Roland Corporation in
the United States and/or other countries.
• Company names and product names mentioned
in this document are trademarks or registered
trademarks of their respective owners.
• MPEG Layer-3 audio compression technology
is licensed from Fraunhofer IIS Corporation and
THOMSON Multimedia Corporation.
• Copyright © 2003 by Bitstream, Inc. All rights
reserved. Bitstream Vera is a trademark of Bitstream,
Inc.
• MMP (Moore Microprocessor Portfolio) refers to a
patent portfolio concerned with microprocessor
architecture, which was developed by Technology
Properties Limited (TPL). Roland has licensed this
technology from the TPL group.
Advertisement
Table of Contents
