Operation; Getting Started; Selecting Active Display Area; Selecting Chapters & Pages - Raymarine ST290 Owner's Handbook Manual

81183_2 S2.book Page 2 Tuesday, May 6, 2003 8:39 AM
2-3-2
If you want to use a different operating profile, or edit a custom profile,
refer to Section 7, Chapter 3, Setting Up Data Displays.

3.2 Operation

Getting started

At power up, each digital instrument is in Normal mode, using the oper-
ating profile that was in use when the instrument was last switched off.
Note: When an instrument is switched on for the first time after installa-
tion, an operating profile must first be selected. See Section 2, Chapter 1
for details.

Selecting active display area

In Normal mode, the upper and lower displays update continuously to
show the current data in their respective chapters.
In order to make any changes to either display area (for example, to select
another page or chapter), you must first select that area as the active
display area. To do this, use the
indicator to the required display area (see Figure 3-2 ).
Upper display active
DEPTH
HEADING
Active
display
indicator
Figure 3-2: Selecting the adjustable display area
Selecting chapters & pages

Chapters

To select a different chapter in either display area (upper or lower):
1. Use the
(see Figure 3-2 ). The active display indicator moves to the selected
area.
Section 2: Using Digital Instruments
or
Lower display active
FT
Active
display
indicator
or button to select the required active display area
ST290 Instrument System Owner's Handbook
button, to move the active display
DEPTH FT
HEADING
D5371-1