Commissioning Complete; 1.3 Manual Set-Up; Requirement; Checking Spx System Operation - Raymarine SmartPilot X-Series Setup Manual

16
Boat completes AutoLearn
!
If you need to cancel the AutoLearn, press
Save new settings
10. The seatrial is now complete. Hold down standby for 2 seconds to exit Seatrial
calibration and save the settings.

Commissioning complete

If you have successfully completed the dockside preparation and seatrial calibration,
the SPX system is now commissioned and ready for use.
After you have used your SPX system, you may decide to change the value of some
parameters to improve pilot performance with your boat. If you feel this is necessary,
use the appropriate procedures under Manual setup , below.

1.3 Manual set-up

Requirement

Checking SPX system operation

Before manually adjusting any settings, familiarize yourself with basic SPX system
operation, as follows:
1. Steer onto a compass heading and hold the course steady at a normal cruising
speed. If necessary, steer the boat manually for a short time to check how the boat
steers.
2. Press auto to lock onto the current heading. The SPX system should hold the
locked heading in calm sea conditions.
3. Use -1, +1, -10 and +10 and observe how the SPX system alters the course to port
and starboard.
4. Press standby to return to manual steering.
SmartPilot X-Series Commissioning & Setup Guide
AutoLearn successful
After
7 to 27
steps
2 sec
Note: If you see a
LRN FAIL message,
press disp to return to
the AUTOLEARN screen
then repeat from Step 2
or
To:
• save AutoLearn calibration settings
• return to STANDBY mode
D10546-1