Chapter 2: Setting Up Graphic Displays; Starting Setup - Raymarine ST290 Owner's Handbook Manual

81183_2 S7.book Page 1 Wednesday, May 7, 2003 1:52 PM

Chapter 2: Setting Up Graphic Displays

2.1 Starting setup

The Graphic Display setup procedures enable you to:
•
•
•
•
Enter User Setup as follows:
1. In normal operating mode, press the
2. Press the
Figure 2-1: ENTER SETUP page
3. Hold down the
4. Within 5 seconds, press the
ST290 Instrument System Owner's Handbook
Local parameters such as responses times, update rate, instrument
profile, display options, data units and default backlighting levels, at
each Graphic Display.
Set the number of pages and the rollover operation of the Favorite
chapter, at each Graphic Display.
Calibrate the ST290 system Speed, Depth and Wind transducers
(from any one Graphic Display).
Set up autopilot parameters (see Section 8 of this handbook), from
any one Graphic Display, when an ST290 Pilot Keypad is being used
to control an autopilot.
Select mode, then cycle to the USER SETUP chapter heading.
button to display the SETUP ACCESS screen.
button for 2 seconds to display the USER SETUP
ENTRY screen (see Figure 2-2 ).
Setup mode. The DISPLAY RESPONSE chapter is displayed.
button to enter Chapter
D5949-1
button to complete the entry into User
7-2-1